Chapter 39. S800 ReadoutCallouts

The S800 data acquisition system uses a data taking framework that requires special handling. This chapter describes the S800 data acquisition system. We also describe the sorts of things that need to be done to integrate the S800 with NSCLDAQ and finally provide a brief description of what you need to do to use the S800 DAQ system.

39.1. S800 Data acquisition system

The S800 system consists of a CAMAC crate that is read via a CC-USB FPGA based crate controller and a VME crate that is read via a VM-USB FPGA based controller. The CAMAC crate contains electronics that read much of the focal plane while the VME crate contains electronics that read out the CRDC's and image 2 detectors when they are in use.

The CC-USB and VM-USB are both block mode readout engines in the sense that each module provides data from several triggers as the result of each transfer to the host. This means that the data from the CC-USB and VM-USB must be built into events by an event builder.

The S800 event builder creates events and re-formats them so that they meet the event formats described in the Operations Technical Development group at https://groups.nscl.msu.edu/opdevtech/wiki. The event builder is also able to serve data to TCP/IP clients both remote and local to the system in which it runs. Data are delivered in 8Kbyte buffers to clients that connect on port 9002. These buffers are formatted with a header that matches the pre-ring buffer data acquisition system format.

The entire system is run by a GUI that is tightly integrated into the readout framework (is part of the readout program in fact). The readout program, however can accept exactly one client on port 8000. The protocol is described at the same wiki.