lrs2228 create module-name ?option...?
lrs2228 config module-name ?option...?
lrs2228 cget module-name
This command ensemble allows you to create and configure LeCroy model LRS 2228 TDC modules. The LRS 2228 is an eight channel Time digitizer.
The create command
allows you to create a new module and assign a
module-name to it so that it can
be referred to in subsequent configuration commands.
You may optionally include configuration switch value pairs
on the create command line.
The config subcommand allows you to
set the configuration parameters for an existing module.
module-name is the name assigned to
that module whe it was created.
The cget command returns as its value the module configuration as a Tcl list where each list element is a sublist containing the name and value of a configuration parameter.
Configuration options are name/value pairs. The name of a configuration option is sometimes called a switch because it resembles the command line switches of command shell commands. For a full description of these options see OPTIONS below.
The following options are recognized by the lrs2228 create and lrs2228 config commands.
-id vsnEach module should be assigned a unique virtual number. If not assigned this will be 0. The data packet returned by the module will be prefixed by the ID. This provides error checking for the code that wil be unpacking the raw data.
-slot camac-slot
Provides the number of the slot in which the CAMAC
module has been installed (camac_slot).
This must match the physical slot the module has been
stuffed in in order to ensure the proper module is
initialized and reads.